Problems and solutions – Fisher-Price 71592 User Manual
Page 11

11
PROBLEM
PROBABLE CAUSE
SOLUTION
Weak reception
Out of range or insufficient signal
Test reception by moving the transmitter and/or receiver to different locations
throughout the house. Relocate the transmitter and/or receiver.
AC adaptor cord(s) not fully extended
Fully extend AC adaptor cord(s).
Improper antenna position
Make sure antennas are pointing upward.
Receiver variable lights
Weak or dead battery in receiver
Replace the battery in the receiver with a fresh 9V alkaline battery or
display does not light
use the AC adaptor.
Interference
Signal interference due to another
Change channel switch on both transmitter and receiver to the other channel.
(buzzing, static, etc.)
nursery monitor or cordless
and signal indicator on
telephone, etc.
receiver is ON
Channel switches not on same
Set channel switch on transmitter and receiver to the same channel.
setting (channel)
Interference
Signal interference due to other
Change channel switch on both transmitter and receiver to the to the
(buzzing, static, etc.)
nursery monitors or cordless
other channel.
and signal indicator on
telephones, etc.
receiver is OFF
Identify and eliminate source of interference. Do not use more than one
transmitter at the same time in the same house.
Channel switches not on same
Set channel switch on transmitter and receiver to the same channel.
setting (channel)
Receiver power is ON but transmitter
Make sure the transmitter is ON. The power indicator should be lit.
power is OFF
Code switches in receiver and
Reset code switches in receiver and transmitter so that they match.
transmitter do not match
Interference
Signal interference due to another
Make sure transmitter power is ON.
(garbled voices) and
Fisher-Price
®
Direct Link Privacy Monitor
™
signal indicator on
Change channel switch on both transmitter and receiver to the other channel.
receiver is ON
We recommend “Checking Privacy” periodically. See page 6.
Feedback
Receiver is too close to the transmitter
Move receiver further away from transmitter.
(squealing or whistling)
Volume is set too high
Lower volume on the receiver.
All five bars on the
Receiver power is ON but
Turn the transmitter power ON.
receiver variable lights
transmitter power is OFF
display light
Out of range or insufficient signal
Move the receiver closer to the transmitter.
Channel switches not on same
Set channel switches on transmitter and receiver to the same channel.
setting (channel)
AC adaptor not properly connected
Check AC adaptor jack-to-socket and plug-to-outlet connections.
to transmitter
PROBLEMS AND SOLUTIONS