Furuno 1942 MARK-2 - Manual (Page 27)

3-8
3.11 Function Controls
The function controls (F1 and F2) work like
the auto-dialing feature of a telephone, auto-
matically executing the function assigned to
them. The function can be turned off by press-
ing appropriate function control again.
Default settings
F1: Shift (brief press) or Zoom (long press)
F2: Ring brilliance
How to register menu items
1. Press the [MENU] key.
2. Press [A/C SEA] (F1) or [A/C RAIN] (F2)
to open the function menu.
[ SETTING FOR F1 KNOB ]
S Sel by omnipad & press ENT. S
EBL
OFFSET
SHIFT ZOOM
RINGS MODE
DISP
DATA
MARK
BRILL
NOISE
REJ
TRAIL
TONE
PULSE
LENGTH
CHARA
CTERS
NO
FNCTN
WPT
MARK
WATCH
MAN
CUSOR
POSITN
EBL
REF
GUARD
IN/OUT
NAV
TALKER
OWN
POSITN
DEAD
SECTOR
VECTOR
LENGTH VECTOR
REF
OTHER
MENU
SHIFT/
ZOOM
ECHO
TRAIL
TRAIL
TIME
ALARM
LEVEL
PANEL
DIMMER
VRM
UNIT
HIS
TORY
COLLI
SION
AUTO
ACQ
ECHO
STRTCH
INT
REJECT
TRAIL
ON/OFF
TUNE
A/M
Figure 3-11 Function menu
3. Select function desired.
4. Press the [ACQ/ENTER] key.
5. Press the [MENU] key to close the menu.
3.12 Suppressing Noise
Electrical noise can be suppressed by turn-
ing on “8. NOISE REJ” on the OTHERS
menu.
3.13 Adjusting Brilliance of
Markers
“2. Mark Brill” on the OTHER menu adjusts
the brilliance of markers other than the head-
ing marker.
3.14 Outputting Target Position
Radar target position data can be output to a
navaid in IEC 61162 format. Select the radar
target with the cursor, and then press and
hold down the [TLL] key to output the data.
This function requires position data and head-
ing signal.
3.15 Dead Sector
When the scanner is installed at a close dis-
tance in front of the wheelhouse the radar
should be set not to transmit within that area,
to prevent microwave hazard. Ask your
FURUNO representative ordealer to provide
this feature.