Fostex VF-16 - Manual (Page 5)

If an error occurs for some reason during the
save operation, the error message as below
appears.
If it appears, press the [ EXIT/NO ] key.
The display returns to the previous screen
before performing the save operation.
Note that saved data before the error message
appears is all invalid.
If you save data to more than one disc, we recom-
mend to put a number on each disc in the saving
order (such as
DISC-1 , DISC-2 , etc.) so that you will
easily know the order for inserting discs when load-
ing data.
In the description for saving data above, we
assume to use a non-recorded CD-RW disc.
If you use a recorded disc (including a disc
on which computer data is recorded), also
note the following.
By performing step 4 in the save operation
procedure shown above ("While "
SCSI " is
flashing, press the [ ENTER/YES ] key.") when
a recorded disc is inserted, the display shows
a warning message, followed by the confir-
mation screen (where "
Sure? " flashes).
With this screen, you can choose whether eras-
ing the recorded data or ejecting the disc.
• To erase the existing (recorded) data
Press the [ ENTER/YES ] key while both " ERASE " and
" Sure? " are flashing.
The display shows the screen below and the VF-
16 starts erasing the disc.
As the erase process progresses, the number of
flashing "
* " increases from left to right.
• To eject the disk
Use the [ JOG ] dial to highlight " Eject " (flashing)
and press the [ ENTER/YES ] key.
The disc is ejected while the display shows " Insert
Disk! ."
By inserting a disc, you can start the save opera-
tion again from the beginning.
Immediately after completing erasing the disc, the
display shows the same screen (for selecting a pro-
gram to be saved) which appears after step 4 is
performed. Hereafter, perform the same proce-
dure as described above.
You cannot abort the save operation before com-
pleted. Especially during the save operation to more
than one disc, if you happen to press the [
EXIT/NO ]
key while removing or inserting a disc, you have to
redo the save operation from the beginning with
the first disc.
Flashing
Increases as the process progresses.
If the message above appears while saving data
to a CD-R disc, you can no longer use the disc.
Flashing
Flashing
Flashing
5