Fisher-Price 74598 - Manual (Page 16)

16
®
• Lift the hood.
• Place the battery in the battery compartment. Make
sure the battery connector extends toward the motor
harness connector.
Battery
Motor
Harness
Connector
Hood
Battery
Connector
1
®
• Squeeze the tabs on each side of the motor harness
connector. Plug the battery connector into the motor
harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again. Do not force
the battery connector into the motor harness connector.
Motor
Harness
Connector
Battery
Connector
2
• Fit the battery clamp (engine cover) over the battery,
motor harness connector and battery connector.
• Insert two #8 x 18 x 1" screws through the holes in the
battery clamp (engine cover) and into the vehicle body.
• Tighten the screws with a Phillips screwdriver.
Do not over-tighten.
Battery Clamp
(Engine Cover)
3
• Lower the hood. Lift the hood latches and fit the short
tabs onto the notches on the hood to fasten it.
Hood
Hood
Latches
4
Battery Installation and Battery Clamp
(Engine Cover) Assembly
H
IMPORTANT! Use only a Power Wheels ® Type H 6 Volt bat-
tery with a Power Wheels ® 25 amp fuse installed. Use
of any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels
® Type H 6 Volt charger before
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.