Fisher-Price V3710 - Manual (Page 7)

V3710pr-0920 7
• Loosen the screw in the battery retainer and remove it.
• Lift the battery retainer and remove the battery from
the battery compartment.
Battery
Battery
Retainer
2
IMPORTANT! The battery must be removed from
your vehicle for the initial charge in order to complete
assembly. After assembly is complete, you do not need
to remove the battery from your vehicle to recharge it.
• Locate the lock fastener in the back end of the seat.
• Using a slotted screwdriver, turn the lock fastener 1/4
turn to the unlocked position .
• Lift the seat from the vehicle.
Lock
Fastener
Unlocked
Seat
Battery
Connector
Battery must be upright
while charging
Charger
Connector
BATTERY CHARGING
Plug the battery connector into the charger connector. •
Plug the charger into a standard wall outlet. •
Notes:
- If power flow to the wall outlet is controlled by
a switch, make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the
charger into a ceiling outlet.
Once the battery is charged, disconnect the battery •
connector from the charger connector. Unplug the
charger from the wall outlet. Refer to the Battery
Installation section for instructions on installing
your battery. If your battery is already installed in
your vehicle, simply re-connect the motor harness
connector to the battery.
1
3