Flymo EasiCut 600XT - Manual (Page 6)

B1 B2
D
Before Use
B3
C1 C2
Before starting your hedge trimmer.
• Securing the cable in the Belt Clip helps keep the
cable away from blade.
1. Push up the hook on the Belt Clip (B1)
2. Place the rear section of the Belt Clip behind your
belt (B2)
3. Push down the hook on the Belt Clip to secure it onto
your belt (B3)
4. Form a loop in the mains cable and push the loop
through the hole in the Belt Clip (C1) ensuring the coil
in the cable is close to the clip.
5. To secure, position the loop over the hook and pull
back (C2).
6. Connect to mains and switch on
7. Remove blade cover (D).
To start your hedge trimmer
EasiCut 420/450/510
1. There are three switch levers fitted to your Hed-
getrimmer.
2. Main switch lever (E1) and one other switch lever
need to be held in the operating position (E2 or F1)
for the product to start.
To start your hedge trimmer
EasiCut 600XT
1. There are four switch levers fitted to your hedge
trimmer.
2. To start, push forward the lock-off button (G1),
squeeze the main switch lever (G2), release lock-off
button.
3. Main switch lever (G2) and one other need to be
held in the operating position (G3, H1 or J1) for the
product to start.
To stop your hedge trimmer
• Move hedge trimmer away from cutting area before
stopping.
1. To stop, release any switch lever.(K, L)
Starting and Stopping
E
K
G H
J
F
L
1
1
2
2
1 3 1
1