First Act FI3002 - Manual

Congratulations on your new electronic guitar!
Please read this guide carefully before you begin playing.
FI3002
Rock-It GuItaR
INSTRUCTION MANUAL
1) Infra-Red Strum
Control
2) Whammy Bar
3) Built-in Speaker
4) Rhythm Keys
(Rock 1, Jazz 1,
Rock 2, Jazz 2)
5) Demo Key
6) Tempo Keys
(T1, T2, T3)
7) Reset (Stop)
8) Volume Control
customer assistance
Phone: 888.551.1115
Email: [email protected] First Act, First Act Discovery, and the
First Act Discovery logo are trademarks
of First Act Inc.
©2008 First Act Inc.
All rights reserved.
FI3002.M.01
1
2
3
4
6
7
8
5
BefoRe you play
InSTall BaTTeRIeS
Batteries required: 3 x “AA” size (not included)
To ReplaCe BaTTeRIeS
1. Open the battery compartment cover, position the batteries in the
compartment and make sure that (+) & (-) are in the correct position.
2. To ensure proper safety and operation, batteries must always be
replaced by an adult. Never let a child use this product unless the
battery door is secured.
3. Keep batteries away from small children. Immediately and safely
dispose of all used batteries.
aTTenTIon
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard (carbon zinc) or rechargeable (Nickel
– Cadmium) batteries.
3. Only the same or equivalent types of batteries are recommended.
4. Non rechargeable batteries are not to be recharged.
5. Rechargeable batteries are to be removed from the product before
being charged.
6. Rechargeable batteries are only to be charged under adult
supervision.
7. Exhausted batteries are to be removed from the product.
HoW To play
aCTIVaTe THe GuITaR
To activate guitar, press any of the rhythm keys or the demo key.
DeMo Key
Press the demo key to hear one of the 4 rhythms (rock 1, jazz 1, rock 2,
jazz 2). Press the demo key again to switch to the next rhythm.
Do not cover the infrared control, or the rhythm will be interrupted.
RHyTHM KeyS
Press any of the rhythm keys to play one of 4 rhythms (Rock 1, Jazz 1,
Rock 2, Jazz 2).
TeMpo KeyS
Press and hold down the T1, T2, or T3 keys to change to a different
tempo while you’re playing a rhythm.
ReSeT Key
The reset key stops the rhythm or demo.
InfRaReD STRuM ConTRol
To play the rhythm by infrared control, activate the guitar, then wave
your hand like you are strumming in the center of the guitar between
the two red lights. Each time you strum, some notes will play. Keep
strumming to play the whole rhythm!
VoluMe ConTRol
Turn the volume dial to control the music volume.
WHaMMy BaR
Press the whammy bar downward to play a whammy lick.
ImpoRtant Safety InStRuctIonS
Please read this section carefully.
1. Read and follow these instructions.
2. Do not use this device near water.
3. Clean only with a dry cloth.
4. Do not use near any heat sources such as radiators, heaters,
or stoves.
5. Only use the attachments/accessories specified by the
manufacturer.
6. Refer all servicing to qualified service personnel. Servicing is
required when the drum pad has been damaged in any way, liquid
has been spilled onto the drum pad, the drum pad has been
exposed to rain or moisture, does not operate normally, or has
been dropped.
WaRnInGS
1. Do not change the parts without professional instructions. Any
change may cause malfunctions.
2. When the guitar is not in use for a long period of time, remove
the batteries to avoid battery corrosion.
3. Keep the wrapping bag out of the reach of children to avoid a
choking hazard.
4. Always move the guitar carefully to avoid damage to outer
covering and inner components.
5. The guitar should not come in contact with acid or alkali. It
should not be operated where there is corrosive or excessively
moist air around to avoid corrosion of the electrical contacts.
note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet or a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio TV technician
for help.
Warning: Changes or modifications to this unit not expressly approved
by the party responsible for compliance could void the user’s authority
to operate the equipment.