Follett FZR Series - Manual (Page 4)

4
Installation
Installing legs – required
1. Remove legs from plastic bag packed inside freezer.
2. Tip freezer back and screw legs in all the way to stop (they will extend
1/8" below base of freezer).
3. Adjust legs as needed to level freezer in both directions. To access
legs, remove the lower front panel. Turn legs clockwise to extend legs.
Installing shelves – required
1. Remove shelves and shelf brackets packed inside freezer.
2. Install shelf brackets in pilasters (insert top tab, squeeze and push in
lower tab).
Changing temperature controller settings – optional
Follett’s temperature controller is pre-programmed with a -25 C (-13 F)
set point and degrees C display. The -25 C (-13 F) set point delivers a
temperature range of -23 to -25 C (-9 to -13 F). Follett’s controller set point
can be changed to deliver up to a -15 C (+5 F) temperature for applications
where a lower temperature is not desired (i.e. ice cream). See page 6 to
change controller settings.
2
1
3
Fig. 1
Fig. 2
Fig. 3