Fujitsu Siemens Computers P7230 - Manual (Page 29)

29
EXIT MENU - LEAVING THE SETUP UTILITY
The Exit Menu is used to leave the setup utility. Follow the instructions for Navigating through the Setup Utility to
make any changes. The table shows the names of the menu fields for the Exit menu and a description of the field's
function and any special information needed to help understand the field's use.
Figure 19. Exit Menu
Table 19: Fields, Options and Defaults for the Exit Menu
Menu Field Shortcut Description
Exit Saving
Changes Press the
F10 key Exit Saving Changes and Exit will store all the entries on every menu of the setup utility to the BIOS
memory and then exit the setup utility. A confirmation message Save Configuration changes and exit
now? [Yes] [No] will be displayed.
Exit Discarding
Changes –— Selecting Exit Discarding Changes and Exit will exit the setup utility with out writing to the BIOS mem-
ory. When the BIOS recognizes this selection it will load the operating system and begin operation.
Load Setup
Defaults Press the
F9 key Selecting Load Setup Defaults will load the factory preset default values for all menu fields, then dis-
play the message Load default configuration now? [Yes] [No]. When confirmed the setup utility will
return to the Exit Menu.
Discard
Changes –— Selecting Discard Changes will load the previous values in BIOS memory for all menu fields. The mes-
sage Load previous now? [Yes] [No] will be displayed. When confirmed the setup utility will return to
the Exit menu.
Save Changes –— Selecting Save Changes will cause the new settings in all menus to be written to the BIOS memory. The
message Save configuration changes now? [Yes] [No] will be displayed. When confirmed, the setup
utility will return to the Exit menu.
Save Changes
and Power Off ___ Selecting Save Changes and Power Off will cause the new settings in all menus to be written to the
BIOS memory, then power the system off. The message Save configuration changes now
and power off?
will be displayed. When confirmed, the setup utility shut down the system.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
Main Advanced Security Power Savings Boot Exit
Item Specific Help
Exit System Setup and
save your changes to
CMOS.
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
Save Changes and Power Off
▲
E x i t M e n u