beautypg.com

Battery installation – Fisher-Price 76921 User Manual

Page 14

background image

• Using a Phillips screwdriver, loosen the screws in the

battery clamp. Remove the battery clamp from the
vehicle body.

• Place the Power Wheels

®

6 Volt (4.0 Amp/Hr.) battery

upright in the battery compartment. Make sure the bat-
tery connector extends toward the rear of the vehicle.

• Make sure a Power Wheels

®

25 amp fuse, in good

condition, is installed in the battery.

Battery

Battery

Clamp

• To unlock the lock fastener, use a slotted screwdriver

to rotate the lock fastener

1

/

4

turn to the unlocked

position .

• Push firmly on one of the back fenders while pulling up on

the same side of the back of the seat to release the tab
on the seat from the slot in the vehicle body.

• Repeat this procedure on the other side of the seat.

• Lift the seat to remove it from the vehicle body.

Battery

Push and

LIft Here

Push and

LIft Here

Motor
Harness
Connector

Battery
Connector

Battery
Connector

14

1

Battery Installation

2

3

Lock
Fastener

Seat

4

H

• Position the battery clamp over the battery with the ends

of the battery clamp aligned with the screw holes in the
vehicle body.

• Insert two #10 x

7

/

8

" screws through the ends of the

battery clamp and into the vehicle body.

• Tighten the screws with a Phillips screwdriver.

Do not over-tighten.

• Plug the battery connector into the motor harness connector.

Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
• Re-assemble the seat to the vehicle body. (See assembly

step 19 on page 12.)

IMPORTANT! Always remember to keep the lock fastener
locked at all times to prevent children from accessing
the battery.

IMPORTANT! Use only a Power Wheels

®

6 Volt (4.0 Amp/Hr.)

battery with a Power Wheels

®

25 amp fuse installed. Use of

any other battery or fuse will damage your vehicle. Make
sure that you charge the battery for at least 18 hours using
the enclosed Power Wheels

®

6 Volt charger before operating

your vehicle for the first time. Charge the battery for at least
14 hours after each use of the vehicle. Never charge the
battery longer than 30 hours. Failure to follow these instruc-
tions may damage your battery and will void your warranty.