Fisher-Price MUSTANG J4390 - Manual (Page 8)

8
J4390pr-0922
ASSEMBLY BATTERY CHARGING
Charger
Connector
A
B
• Plug the charger connector into the battery A
.
• Plug the charger into a standard wall outlet B .
Notes:
- If power flow to the wall outlet is controlled by a switch,
make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug the charger
into a ceiling outlet.
• Before first-time use, charge the battery for at least 18 hours.
Never charge the battery longer than 30 hours.
• Recharge the battery for at least 14 hours after each use of
your vehicle. Do not charge the battery longer than 30 hours.
• Once the battery is charged, disconnect the battery connector
from the charger connector. Unplug the charger from the wall
outlet. The battery is now ready to be installed in your vehicle.
Please see the Battery Installation section on page 18 for
detailed instructions on installing your battery. If your battery
is already installed in your vehicle, simply re-connect the motor
harness connector to the battery.
WARNING
Children can be harmed by small parts,
sharp edges and sharp points in the
vehicle's unassembled state, or by electrical
items. Care should be taken in unpacking
and assembly of the vehicle. Children should
not handle parts, including the battery,
or help in assembly of the vehicle.
• Place the vehicle upside down.
• Slide the bumper support, ribbed side up, into the slot in the
front end of the vehicle.
• Insert two 1 /
4
" x 1 1 /
4
" screws into the bumper support and tighten.
Bumper Support
1
BOTTOM VIEW
In the unassembled state, this package
contains small parts. Adult assembly
is required.
CAUTION