FCI Home Appliances COGB33062 - Manual (Page 12)

Use & Care Manual
Model COGB ENGLISH
12
Parts and materials Suggested cleaners Suggestions/Reminders
Exterior finish
(Porcelain enamel)
• Hot sudsy water: rinse and dry
thoroughly.
• Non abrasive cleansers: Ammonia,
Fantastic®, Formula 409®.
• Mild abrasive cleansers: Bon Ami®,
Ajax®, Comet®.
• Liquid cleaners: Kleen King®, Soft
Scrub®.
• Acidic and sugar-laden spills deteriorate
the porcelain enamel. Remove soil
immediately.
• Do not use wet sponge or towel on hot
porcelain.
• Always apply minimal pressure with
abrasive cleaners.
Control knobs
(Plastic)
• Hot sudsy water: rinse and dry
immediately.
• If necessary, remove knobs (lift
straight up).
• Do not soak knobs.
• Do not use abrasive scrubbers or
cleansers.
• Do not force knobs onto valve shaft.
• Pull knobs straight away from control
panel to remove.
• When replacing knobs, make sure
knobs are in the OFF position.
• Do not remove seats under knobs.
Exterior finish
(Stainless Steel)
• Nonabrasive cleaners: Hot water
and detergent. Fantastic®, Formula
409®. Rinse and dry immediately.
• Cleaner polish: Stainless Steel
Magic® to protect the finish from
staining and pitting; enhances
appearance.
• Hard water spots: Household white
vinegar.
• Mild Abrasive Cleaners: Kleen
King® stainless steel liquid cleaner,
Cameo® aluminum & stainless steel
cleaner, Bon Ami®.
• Heat discoloration: Bar Keepers
Friend®.
• Stainless steel resists most food stains
and pit marks providing the surface is
kept clean and protected.
• Never allow food stains or salt to remain
on stainless steel for any length of time.
• Rub lightly in the direction of polish
lines.
• Chlorine or chlorine compounds in some
cleaners are corrosive to stainless steel.
Check ingredients on label before using.
• Always apply minimal pressure with
abrasive cleaners especially on graphics.
Igniters
(Ceramic)
• Carefully wipe with a cotton swab
dampened with water, ammonia or
Formula 409®.
• Gently scrape soil off with a
toothpick.
• Avoid excess water on the igniter.
A damp igniter will prevent burner from
lighting.
• Remove any lint that may remain after
cleaning.