Fisher-Price M9779 User Manual

Page 14

M9779b-0920

BACK VIEW

• Insert the "T" fastener end of a short seat belt strap through

the slot near the outer edge of the seat. Make sure the
fastener side of the seat belt faces inward.

Note: You will pull only one T-Loop through the slot.
• Repeat this procedure to assemble the other short seat

belt strap.

• Insert each fastener end of the long seat belt strap through

the slots in the center of the seat. Make sure the fasteners
face the outer edge of the seat.

• Pull each side of the long seat belt strap evenly through

the slots. Make sure to pull each T-loop through a slot.

• Turn the vehicle upright.
• Insert both tabs on the back edge of the seat into the slots

inside the bed.

Short Seat Belts

Long Seat Belt

• Insert two screws through the back of the seat and into

the vehicle. Tighten the screws.

Slots

Seat

• Align the tabs on a hubcap with the slots in a rear wheel.

“Snap” a hubcap into the center of the rear wheel.

Hint: If the hubcap does not "snap" into place, you may not
have assembled the wire clip properly. Remove the wire clip
and refer back to step 18.
• Repeat steps 17 - 21 to assemble the other rear wheel, wire

clip and hubcap.

Hubcap

Screws