Fisher & Paykel RX256 - Manual (Page 16)

14
Temperature controls (RX256DT7X1)
Reset Filter
The water filter needs to be replaced every 12 months, or after 750 gallons (2838 liters) of
water has been dispensed (which ever is sooner). To remind you of this, the orange Order light
will illuminate after 11 months or once 90% of the volume of water has been dispensed. The
red Replace light will illuminate after 12 months, or once 750 gallons (2838 liters) have flowed
through. Install a new filter immediately when the red light shows up (see page 25).
After replacing the filter, reset the filter by pressing and holding the RESET FILTER button for two
seconds. Both lights will go off.
Temp Alarm
The Temp Alarm system will tell you if compartment temperatures exceed normal operating
temperatures due to a power outage (or other event). When activated, the Temp Alarm light will
illuminate.
If the temperatures exceed operating limits, the display will show the highest compartment
temperatures reached when the power was out. Once the refrigerator starts to cool, the display
will alternate between the current compartment temperature and the highest temperature
reached. An audible alarm will sound repeatedly.
Press the TEMP ALARM button once to stop the audible alarm. The Temp Alarm light will
continue to flash and the temperatures will alternate.
To turn off Temp Alarm, press and hold the TEMP ALARM button for three seconds. The indicator
light will go off.
Door Alarm
The Door Alarm will alert you when one of the doors has been left open for five continuous
minutes. This is to ensure your food will not spoil accidentally. When this happens, an audible
alarm will sounds every few seconds until the door is closed, or the DOOR ALARM button is
pressed.