Meridian Audio 565 - Manual (Page 59)

Troubleshooting
55
Hum on analogue input
There is no reason for the 565 to produce hum on the analogue
input.
❍ Check the source equipment. Disconnect each source in turn.
❍ If the hum originates from a ground loop an antenna or cable
supply may be the cause, in which case an antenna-lead
isolator should be fitted.
❍ If the 565 seems to be the cause of hum consult your dealer.
Poor sound quality
Poor sound quality will usually result from driving an analogue
input too hard.
❍ Turn down the analogue input level.
❍ To optimise this use the ADC Check procedure; see ADC
Check, page 43.
There is radio interference
The 565 is a digital audio and computing device which has been
designed to very high standards of electromagnetic
compatibility.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
❍ Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the 565 and its
cabling.
❍ Ensure that the receiver uses well-screened antenna cable.
❍ Relocate the receiver with respect to the 565.
❍ Connect the receiver and this product to different AC outlets.
❍ If the problem persists contact you dealer.
Audio problems