FELLOWES PS60C-2 - Manual (Page 3)

2
IMPORTANT SAFEGUARDS
• NEVER insert hands or fingers into paper entry as serious personal
injury may result.
• THIS MACHINE IS NOT A TOY. Keep children and pets away from
shredder AT ALL TIMES as serious injury may result. Always unplug
shredder when not in use.
• Keep loose objects (jewelry, ties, long hair) away from shredder.
These items and others like them may cause serious injury if they
accidentally fall into the paper entry.
• Confetti cut shredders contain sharp edges on the underside of the
machine. Use caution when positioning the shredder head onto the
basket.
• Do not exceed recommended sheet capacity.
• Do not shred plastic (except credit cards), continuous forms, adhe-
sive labels, transparencies, newsprint, or cardboard.
• This personal shredder is intended for paper only. Do not attempt
to shred large paper clips or other hard materials (except staples
and small paper clips).
• Do not place shredder near or over a heat source or water.
• Always turn off and unplug unit before moving or cleaning and
when not in use.
• Do not insert aerosol cleaners into or around the shredder. Some
agents may combust, causing serious injury.
• Never use flammable synthetic oil, petroleum- based or aerosol
lubricants to oil the cutting blades. Some agents may combust,
causing serious injury. Use only a recommended oil in a non-
aerosol container. See “MAINTENANCE.”
• Do not use this product if it or the cord has been damaged in any
way.
• Do not open the cover for any reason. Doing so can expose you to
dangerous voltages and will void your warranty.
Power Cord Care
• Place power cord in an easily accessible position, because it is the
main disconnect switch.
• Do not place machine where adults, children or animals may walk
on the cord.
• Do not rest anything on the power cord.
• If an extension cord is used, be sure that all products plugged into
the extension cord do not exceed the extension cord ampere rat-
ing.
Figure 1
A. Basket
B. Paper entry
C. Shredder head D. Power switch
E. LEDs (red and green)
F. Viewer
PARTS OF THE SHREDDER
ASSEMBLY
NOTE: Model PS60C-2 will operate only when used with the supplied
basket. The supplied basket has a built-in safety feature which pre-
vents the shredder from operating if used with any other basket or if
improperly assembled.
To assemble shredder head onto basket:
Confetti cut shredders (Model PS60C-2 only) con-
tain sharp edges on the underside of the shredder
head. Use caution when positioning the shredder head onto the bas-
ket.
1. Position shredder head over basket as shown in
Figure 1.
2. For Model PS60C-2 ONLY: Align slot on back of shredder head
with the tab on the inside rear of the basket.
3. Lower shredder head onto basket (while maintaining tab/slot
alignment).
B
A
D
E
F
C
Back View
Align
Align
CAUTION