Fisher & Paykel DD60D - Manual (Page 3)

PARTS SUPPLIED
Clamp (1) Wire clip (2) Phillips
16 mm
screws (9)
Drain hose
support (1)
Moisture protection
tape (1)
(to prevent moisture
damage)
Drain hose
joiner (1)
Top
mounting
brackets (2)
OPTIONAL
Prefinished toekick (1)
white or black
Rubber
washer for
inlet hose (1)
Hexagonal
socket (2)
(long & short)
4
If the Drain hoses supplied are not long enough to reach your services, you must use a Drain Hose Extension Kit P/N 525798 which will extend the drain hoses by 3.6 m. The kit is available from the nearest
Fisher & Paykel Authorised Service Centre or our local website listed at the end of this document.
CAVITY PREPARATION 5
These marks indicate mounting bracket screw locations
Preferred position. If adequate clearance, services hole can be higher to
clear toekick space.
If hole is higher, ensure drain hoses are routed straight into the waste connection.
*
Water Connection
Recommended COLD (Maximum 60°C).
¾ “ BSP (GB20) to suit flat washer.
Water Pressure Max Min
Water softener models 1 MPa (145 psi) 0.1 MPa (14.5 psi)
Other models 1 MPa (145 psi) 0.03 MPa (4.3 psi)
Drains will need to be separated to satisfy kosher requirements.
We suggest you confirm acceptability with your local rabbi in respect to kosher installations.
Note: Se
rvices can be locat
ed
either side of DishDra
wer®.
10 mm
max. 450 mm
220-240 VAC
min. 9 A
Moisture protection
tape must be applied.
min. ø60 mm
* *
min. 200 mm
Water supply
(2,1) -1- 599684B DD60D installA2 NZGB.indd 6/7/09 11:49:15 AM (2,1) -1- 599684B DD60D installA2 NZGB.indd 6/7/09 11:49:15 AM