FELLOWES 320 - Manual (Page 7)

320
320C
380
Paper shredder 320-2HS 380C
Edition 01/03 7
Door contact ajar / bag full
Red LED lights
– Paper shredder switches off automatically.
• Press rocker switch to center position (2).
• Make sure cabinet door is properly
closed and/or exchange cut material
bag.
• Return switch to "on" position (1) and
continue shredding
10. Maintenance
(Cross cut unit only)
– When shredding capacity drops or the
noise increases.
• Apply oil over full width of cutting
cylinders through the paper entry
(Fellowes Powershred Lubricant
# 35250).
CAUTION: Do not use flammable
synthetic oil, petroleum-based
products, or aerosol lubricants of any
kind.
• Run cutting system forward and back-
ward several times without feeding
paper.
• Continue shredding.
8. Checklist for Inoperative Machine
If the equipment does not work properly, please
check the following points first:
– Is the plug inserted?
– Is the switch turned on?
– Is the cabinet door closed?
– Is waste receptacle full?
Empty waste bag.
– Is there a paper jam in the shredder?
– Is the motor overheated?
Switch machine off and allow motor to
cool down for approximately 15–20 min.
If none of the above applies and the equipment still
does not run, please contact our customer service
department.
9. Malfunctions
Paper jam
• Press rocker switch to center position (2)
to stop the cutting system
• Press and hold down rocker switch in
pos. 3 to reverse the cutting system and
back out jammed material
(paper is pushed out)
Caution!
Do not attempt to force the jammed
material through the machine by
alternating the cutting system between
forward and reverse
• Remove excess paper
• Return switch to pos. 1 and continue
shredding in smaller quantities so as not
to jam the machine further
Note:
The 320-2HS will not run forward again
unless the jammed material has been
completely removed from the throat
2
2
3
3
1
1
3
1
1