FMI FEF26 - Manual (Page 6)

WARNING : Before attempting to perform any maintenance on this appliance, turn all controls
to the “OFF” position and unplug. Allow the appliance to be “OFF” for at least 10 minutes before
performing any maintenance in order to allow all components to cool properly.
CARE AND MAINTENANCE
Replacing Light Bulbs:
Make sure that all controls are off and that the appliance is unplugged.
Wear latex gloves to ensure th at grease/oil from your hands does not transfer to the bulbs.
Take hold of each side of the bulb cover panel at the bottom of the firebox and pull straight
out (See Fig.5). You can see three 40W light bulbs in the firebox (See Fig.6).
Examine the light bulbs to determine which bulbs require replacement.
Remove the burnt out bulb and replace with a new 40W bulb –
Replace the cover panel (See Fig.7).
do not over tighten.
To remove dust from glass window, use clean dry cloth.
To remove fingerprints or other marks from glass window, use clean damp cloth. Do not spray
glass cleaner or other liquids directly onto the window.
Clean metal surfaces with a clean damp cloth making sure not to push dust or debris into any air
intake or exhaust vents.
Do not use abrasive cleaners or spray liquids on any part of the appliance.
Periodic cleaning/vacuuming of the fan/heater unit is strongly recommended to ensure that no
dirt or foreign objects build up.
WARNING: DO NOT EXCEED THE RECOMMENDED BULB WATTAGE.
Replace the bulb cover panel.
Fig.5 Fig.6 Fig.7
Cleaning:
6