beautypg.com

Replacing lost transmitters, Locks and security – FORD 2006 Crown Victoria User Manual

Page 88

background image

2. Do not wipe off any grease on the
battery terminals on the back
surface of the circuit board.

3. Remove the old battery. Note: Please refer to local regulations when
disposing of transmitter batteries.

4. Insert the new battery. Refer to the diagram inside the remote entry
transmitter for the correct orientation of the battery. Press the battery
down to ensure that the battery is fully seated in the battery housing
cavity.

5. Snap the two halves back together.

Note: Replacement of the battery will not cause the remote transmitter
to become deprogrammed from your vehicle. The remote transmitter
should operate normally after battery replacement.

Replacing lost transmitters

Take all your vehicle’s transmitters to your authorized dealer if service is
required.

If a remote transmitter has been lost and you would like to remove it
from the vehicle’s memory, or you would like to purchase additional
remote transmitters and have them programmed to your vehicle:
• Take all your vehicle’s transmitters to your authorized dealer for

programming, or

• Perform the following programming procedure yourself:

2006 Crown Victoria (cro)
Owners Guide (post-2002-fmt)
USA
(fus)

Locks and Security

88

This manual is related to the following products: