Fisher-Price CATERPILLAR 73260 - Manual (Page 15)

Battery Installation
• While pushing the battery clamp, place a Power Wheels ®
6 volt battery upright in the battery compartment.
Battery Clamp
6 Volt Battery
IMPORTANT! Use only a Power Wheels ® 6 volt battery
with A-style connector and built-in thermal fuse. Use of
any other battery will damage your vehicle. Make sure that
you charge the battery for at least 18 hours using the
enclosed Power Wheels
® Super 6 ™ Volt charger before
operating your vehicle for the first time. Charge the battery
for at least 14 hours after each use of the vehicle. Never
charge the battery longer than 30 hours. Failure to follow
these instructions may damage your battery and will void
your warranty.
• Fit both small motor harness connectors to the small
power connectors.
Hint: Do not force the connections together. If they do
not easily fit together, turn one of the connectors over
and try again.
• Plug the large battery connector into the large motor
harness connector.
Note: If the battery connector will not plug into the motor
harness connector, turn it over and try again! Do not force
the battery connector into the motor harness connector.
Small Motor
Harness Connector
Large Battery
Connector
Large Motor
Harness Connector
Small Power Connectors
Gap No Gap
Incorrect Correct
• Lift the tab on the back of the seat back to unlatch the
peg from the hole in the vehicle body.
Hint: This may require a lot of force.
• Remove the seat back from the vehicle body.
Seat Back
Tab
Small Motor
Harness Connector
• Fit the tabs on the front of the seat back into the slots
inside the vehicle body.
• Push down on the back of the seat back to insert the peg
into the hole in the vehicle body.
IMPORTANT! Remember to keep the seat back secured to
the vehicle at all times to prevent children from accessing
the vehicle battery compartment.
Peg
Tabs
Seat Back
Slots
Hole
15
1
3
2
4
H