FELLOWES P-12C - Manual (Page 3)

BASIC PRODUCT MAINTENANCE
Shredder comes fully assembled. Remove basket packaging material and plug-in. Disconnect Power Switch must be in ON ( I ) position to operate shredder.
PAPER OR CARD
1
Set to Off (O)
BASIC SHREDDING OPERATION
15
15
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
Set to Reverse (R)
2-3 seconds
* Apply oil
across entry
Set to Off (O)
2
Press Auto-On ( I )
3
Feed into paper
entry and release
2
1 2 3
All cross-cut shredders require oil for peak
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
stop running. To avoid these problems, we
recommend you oil your shredder each time
you empty your waste bin.
OILING SHREDDER
Hold card at edge
4 5
Feed into center of
entry and release
Set to Off (O)
6
TO TEST SAFESENSE ® TECHNOLOGY
1 2 3
Press Auto-On (I) Touch test area and
look for the SafeSense ®
indicator to illuminate
Sensor lights up
Continuous operation:
4-5 minutes maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
4-5-minutes will trigger
20-minute cool down period.
TROUBLESHOOTING
Paper jam: Set to Off (O), remove shredder head and empty bin. Replace shredder head, and follow any or all of the below procedures.
Alternate slowly back and forth Set to Reverse (R) Set to Off (O)
and unplug
Pull uncut paper from
paper entry
Set to Reverse (R)
5
ATTENTION: If the SafeSense ® light remains on, you must engage the Override Switch in order to perform steps above.
Once the jam is cleared, reset the SafeSense ® feature. (See SafeSense ® instructions below.)
1 3 2 4 6
Shredder doesn’t start:
Yellow - SafeSense ® active
Yellow flashing - SafeSense ®
not active
Make sure control switch is in
Auto-On ( I ) position
Wait 20 minutes for red light to
turn off
SafeSense ® paper jam: If the SafeSense ® feature activates (SafeSense ® light remains on) to cause the user
to think the shredder has jammed when it has not, use the Override Switch to deactivate the SafeSense ®
feature and clear the paper. Warning – when switch is in override position, the SafeSense ® light will flash and
the SafeSense ® feature will NOT function. Once the paper is cleared, reset the SafeSense ® feature.
SafeSense ® override switch
Active Not active
Sensor light illuminated–paper jammed
OR