FUJITSU B2610 - Manual (Page 6)

6
L i f e B o o k B S e r i e s N o t e b o o k B I O S
Primary Master Submenu of the Main Menu
The Primary Master submenu identifies what ATA/
ATAPI devices are installed.
Note: Actual hard drive label shown may vary. Depending
on the drive type, information such as cylinders, heads and
sectors may or may not be displayed.
Figure 2. Primary Master Submenu
Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu
Menu Field Options Default Description
Type: • Auto
• None
• Hard Disk [Auto] Selects the ATA/ATAPI device type. Select Auto to have the
type automatically identified by the BIOS at POST. If None is
selected, all of the following Set-up items do not appear. If
Hard Disk is selected, you must specify the number of Cylin-
ders, Heads, and Sectors for the drive.
Cylinders: • A number
between 0
and 65,535
–— This item appears only when the type is identified as Hard
Disk. When Hard Disk is selected, you can change the value.
This field is changed by incrementing (pressing the [Space-
bar]) or by typing in the number.
Heads: • A number
between 1
and 16
–— This item appears only when the type is identified as Hard
Disk. When Hard Disk is selected, you can change the value.
This field is changed by incrementing (pressing the [Space-
bar]) or by typing in the number.
PhoenixBIOS Setup Utility
F1 Help
ESC Exit
Select Item
Select Menu
-/Space Change Values
Enter Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit
▲
Main Advanced Security Power Boot Info Exit
Item Specific Help
Select ATA/ATAPI drive
installed here.
[Auto]
The BIOS auto-types the
drive on boot time.
Except [Auto]
You enter parameters of
the drive.
[None]
The drive is disabled.
Primary Master [TOSHIBA MK2016GAP-(PM)]
Type: [ Auto]
Maximum Capacity: 20004MB
Multi-Sector Transfers: [16 Sectors]
LBA Mode Control: [Enabled]
PIO Transfer Mode: [FAST PIO 4]
DMA Transfer Mode: [Ultra DMA 2]
Quilt-3 BIOS.fm Page 6 Thursday, June 6, 2002 9:26 AM