FORD 2002 F-250 - Manual (Page 240)

Traction-Lok axles. Ford design rear axles contain a synthetic lubricant
that does not require changing unless the axle has been submerged in
water. Dana rear axles also contain a synthetic lubricant but do require a
change. Refer to your “Service Guide” for change intervals on Dana rear
axles.
2 Ensure the correct automatic transmission fluid is used. Transmission
fluid requirements are indicated on the dipstick or on the dipstick
handle. Check the container to verify the fluid being added is of the
correct type. Refer to your scheduled maintenance guide to determine
the correct service interval.
Some transmission fluids may be labeled as dual usage, such as
MERCON
௡ and MERCON௡ V. These dual usage fluids are not to be used
in an automatic transmission that requires use of the MERCON
௡ type
fluid. However, these dual usage fluids may be used in transmissions that
require the MERCON
௡ V type fluid.
MERCON
௡ and MERCON௡ V type fluids are not interchangeable.
DO NOT mix MERCON
௡ and MERCON௡ V. Use of a transmission
fluid that indicates dual usage (MERCON
௡ and MERCON௡ V) in
an automatic transmission application requiring MERCON
௡ may
cause transmission damage. Use of any fluid other than the
recommended fluid may cause transmission damage.
ENGINE DATA
Engine 5.4L V8 engine 6.8L V10 engine
Cubic inches 330 415
Required fuel 87 octane 87 octane
Firing order 1-3-7-2-6-5-4-8 1-6-5-10-2-7-3-8-4-9
Spark plug gap
1.3-1.4 mm
(0.052-0.056 inch) 1.3-1.4 mm
(0.052-0.056 inch)
Ignition system Coil on plug Coil on plug
Compression ratio 9.0:1 9.0:1
Maintenance and Specifications
240