Festool ETS 150/5 EQ - Manual (Page 3)

3
21 Check for misalignment or binding of
moving parts, breakage of parts, and any
other condition that may affect the tools
operation. If damaged, have the tool
serviced before using. Many accidents are
caused by poorly maintained tools.
22 Use only accessories that are
recommended by the manufacturer for
your model. Accessories that may be suitable
for one tool, may become hazardous when used
on another tool.
Service
23 Tool service must be performed only by
qualified repair personnel. Service or
maintenance performed by unqualified personnel
could result in a risk of injury.
24 When servicing a tool, use only identical
replacement parts. Follow instructions in
the Maintenance section of this manual. Use
of unauthorised parts or failure to follow
Maintenance instructions may create a risk of
electric shock or injury.
Symbols
V Volts
A Amperes
Hz Hertz
W Watt
Alternating current
n
0
No load speed
Class II Construction
rpm Revolutions per minute
spm Strokes per minute
Ø Diameter
Intended use
The sanders are designed for sanding wood,
plastic, composite materials, paint / varnish,
filling material and similar materials.
Metal and materials with an asbestos content
must not be processed with these tools.
The machines must not be damp nor operated
in a damp environment for electrical safety
reasons. The machines may only be used for
dry sanding.
Technical data ETS 150/3 EQ ETS 150/5 EQ
Wattage W 310 310
No load speed rpm 6 000 - 10 500 6 000 - 10 500
No. of strokes spm 12 000 - 21 000 12 000 - 21 000
Sanding stroke mm (in.) 3.0 (0.12) 5.0 (0.20)
Sanding base, Ø mm (in.) 150 (5.9) 150 (5.9)
Weight kg (lbs) 1.8 (4.0) 1.8 (4.0)
Safety level UL 745, CSA C22.2 No. 745
The user bears sole responsibility
for any damage or accidents resulting from
incorrect use.
Electrical connection and operation
The mains voltage must correspond with the
voltage on the rating plate!
See the following figure for connection and dis-
connection of the power cable.
Always switch the machine off
before connecting or disconnecting the power
cable!
Various dust created by power
sanding, sawing, grinding, drilling and other
construction activities contains chemicals
known (to the State of California) to cause
cancer, birth defects or other reproductive
harm. Some examples of these chemicals are:
•lead from lead-based paints,
•crystalline silica from bricks and cement and
other masonry products, and
•arsenic and chromium from chemically-
treated lumber.
The risk from these exposures varies,
depending on how often you do this type of
work.
To reduce your exposure to these
chemicals: work in a well
ventilated area, and work with
approved safety equipment, such
as dust masks that are specially
designed to filter out microscopic
particles.