Farallon Communications NetLine PCI Card - Manual (Page 12)

8 Chapter 3
PCI CARD LED S
The NetLINE PCI Card LEDs can give you information about link status
and network activity. After the card and driver are properly installed,
the LEDs will become active.
LINK : This indicator gives you information about the link status of the
RJ-45 connection. A steady green light indicates that the PCI card is
properly connected and receiving a signal. If this LED is not lit, it may
indicate one of the following:
■ No twisted pair cable is connected.
■ The network cable is not properly connected or is faulty.
■ A non–10Base-T device is connected at the other end of the
network cable.
■ The network cable exceeds 100 meters.
■ The card is not receiving power.
■ Link test is disabled.
■ You are using a ‘straight through’ 10Base-T cable to connect
directly to another workstation without a hub.
■ You are using a ‘crossover’ cable to connect to a hub.
ACT (Activity) : A flashing light indicates that network data is being
transmitted or received by the PCI card. If the light is off, it indicates
there is no network activity.
LINK
ACT