Fisher 1225-X - Manual (Page 11)

9
ZERO MOTION PINPOINT MODE
The pinpoint mode requires no tuning, no motion, detects
all metals and in normal soil it’s even more sensitive than the
search mode. Precise target location is a snap.
1. Once the presence of a buried target is
identified by the “beep beep” of the 1225-X,
simply place the coil lightly on the ground away
from the target area. Push the PINPOINT button
and hold. (At maximum sensitivity you may hear a
faint tone which will disappear as soon as the coil
is raised.)
2. Raise the coil one-half inch or so and move
it from side to side across the target area a few
times.
3. Stop the search coil over the spot you receive
the loudest response.
4. Now move the coil slowly forward and back a
couple of times, again stopping over the strongest
response.
5. Move the coil side to side one more time and
stop over the strongest signal once again. Your
target should be in the center of the search coil.
6. For quick and accurate pinpointing of strong
signals, place the coil on the ground very close
to the target and push and hold the PINPOINT
button. You have now “tuned-out” most of the
target signal so that when you raise the coil for
pinpointing you will only receive a response
directly over or very nearly over the target.
PINPOINTING