Frymaster Ultimate Electric Series - Manual (Page 9)

ULTIMATE ELECTRIC SERIES FRYERS
CHAPTER 2: INSTALLATION INSTRUCTIONS
2-1
2.1 General
Proper installation is essential for the safe, efficient, trouble-free operation of this appliance.
Qualified, licensed, and/or authorized installation or service personnel, as defined in Section 1
of this manual, should perform all installation and service on Frymaster equipment.
Failure to use qualified, licensed, and/or authorized installation or service personnel (as
defined in Section 1 of this manual) to install or otherwise service this equipment will void the
Frymaster warranty and may result in damage to the equipment or injury to personnel.
Where conflicts exist between instructions and information in this manual and local or
national codes or regulations, installation and operation shall comply with the codes or
regulations in force in the country in which the equipment is installed.
Service may be obtained by contacting your local Factory Authorized Service Center.
NOTICE
All fryers shipped without factory supplied cords and plug assemblies must be hardwired
using flexible conduit to the terminal block located on the rear of the fryer. These fryers
should be wired to NEC specifications. Hardwired units must include installation of restraint
devices.
DANGER
Adequate means must be provided to limit the movement of this appliance without
depending on or transmitting stress to the electrical conduit. A restraint kit is provided with
the fryer. If the restraint kit is missing contact your local Frymaster Factory Authorized
Service Center (FASC) for part number 826-0900.
NOTICE
If this equipment is wired directly into the electrical power supply, a means for
disconnection from the supply having a contact separation of at least 3-mm in all poles must
be incorporated in the fixed wiring.
NOTICE
This equipment must be positioned so that the plug is accessible unless other means for
disconnection from the power supply (e.g., a circuit breaker) is provided.
DANGER
The electrical power supply for this appliance
MUST be the same as indicated on the rating
and serial number plate located on the inside of the fryer door.
NOTICE
If this appliance is permanently connected to fixed wiring, it
MUST be connected by means
of copper wires having a temperature rating of not less than 167°F (75°C).