Fujitsu Siemens Computers C551 - Manual (Page 22)

Color monitor C551
14 - English A26361-K610-Z100-3-5E19
Electrical data
Video:
Synchronization:
Horizontal frequency:
Refresh rate:
Maximum pixel rate:
Power supply:
analog, positive, 0.7 Vpp, 75 Ohm
TTL
30 kHz .... 54 kHz (multi-scanning)
50 Hz .... 120 Hz
70 MHz
100 V - 240 V
±
10%
60 Hz/50 Hz ± 3 Hz, < 1.5 A
Power consumption (see power
management): < 65 W (ON, Normal mode)
< 15 W (Standby mode)
< 15 W (Suspend mode)
< 5 W (OFF mode)
Environmental conditions
Environment class 3K2, IEC 721
Rated range of operation:
Humidity:
Limit range of operation:
Humidity:
15 °C .... 35 °C
10 % .... 80 %
0 °C .... 40 °C
10 % .... 80 %
Condensation must be avoided.
VESA-DDC-compatible VGA interface
Your monitor is equipped with a VESA-DDC-compatible VGA interface. VESA-DDC (Video
Electronics Standard Association, Display Data Channel) is used as the communications interface
between the monitor and the PC. If your PC is equipped with a VESA-DDC-compatible VGA
interface, it can automatically read the data for ensuring optimum operation from your monitor and
select the appropriate settings.
i
If the monitor C551 is not yet displayed in the list of monitors, you can select one of the
following monitors instead:
Fujitsu Siemens 154V or Siemens MCM 153V, MCM 1404, MCM 1405 ND
Preset operating modes
i
The display position and size have been set to optimum values at the factory for the
operating modes listed above. Depending on the screen controller used, it may be
necessary to adjust the display position and size. In this case, you can change and save
the settings (see "
Operation of the monitor ").