Fostex VR800 - Manual (Page 12)

12
VR800 Quick Operation Guide
Before turning off the power to the VR800
Before turning off the power to the VR800 and the connected SCSI drive, check the following items:
* The SCSI disk is not being accessed. (The ACCESS LED is turned off.)
* The VR800 has exited the setup mode and displays the ABS or BAR/BEAT/CLK time base.
* The output volume of the VR800 all connected audio devices is set to minimum.
1
First, turn on the power to the SCSI drive loaded with the removable disk.
First, make sure that the orange LED on the SCSI drive lights up in green and that the
removable disk is not being accessed, and then turn on the power to the VR800.
2
Ejecting a removable disk from the SCSI drive
Follow the procedure below to eject a removable disk from the SCSI drive after the VR800 exits the setup mode
and disk access has stopped. You cannot eject a removable disk using the eject button on the drive.
Press and hold down the SHIFT key and press the EXIT/NO key.
The removable disk will be eject from the current SCSI drive.
1
2
Turn the JOG dial to select [Format ?] and press the EXECUTE/YES key.
The VR800 displays the ID number of the connected SCSI drive and flashes [SURE ?].
Use the JOG dial to select the desired record mode.
3
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
44.1kHz DIGITAL
44.1kHz
SETUP
DRIVE
AUTO A.PUNCH
SYNC OUT
CLK SCSI
DIGITAL 44.1kHz
SETUP
SURE ?
DRIVE
AUTO A.PUNCH
SYNC OUT
SCSI
DIGITAL
Turning on the power again with a removable disk loaded in the SCSI drive
There is no procedure for turning on the power without a removable disk loaded in the SCSI drive but if power is
switched off with a disk, and then power needs to be switched on again, follow the procedure below: