Final Sound S110 - Manual (Page 13)

FINAL SOUND SOLUTIONS S110 SUBWOOFER MANUAL vs. 1.6 -US- c FSS 2006R 13
(Figure 5) If you have an AV-receiver for five, six or seven channel Dolby Digital/DTS
surround sound which has separate pre out connections.
• You can only use the subwoofer’s special high pass filter facilities for driving the left
and right electrostatic front panels, if you connect an additional two channel power
amplifier.
• Connect the AV-receiver’s left and right RCA pre amp out terminals to the
subwoofer’s left and right line in RCA terminals.
• Connect the subwoofer’s line out RCA terminals to the additional two channel power
amplifier’s RCA input terminals.
• Connect the left and right front panels to the additional two channel power amplifier’s
loudspeaker binding posts.
• Connect the rear loudspeakers and the center panel to the AV-receiver’s appropriate
loudspeaker output terminals.
• Adjust the ‘speaker size’ in the receiver’s menu to LARGE. This will cancel the
receiver’s LFE output and route all the low frequencies to the front channels.
• Follow Procedure B for adjusting the subwoofer.
(+) If you use a standard AV-receiver (with integral power amplifiers) with separate
outboard power amplifiers.
• You can use the subwoofer’s special high pass filter facilities for driving the left and
right electrostatic front panels, if you use at least outboard power amps for the front
channels.
• Connect the AV-receiver’s left and right RCA pre amp out terminals to the
subwoofer’s left and right line in RCA terminals.
• Connect the subwoofer’s line out RCA terminals to the additional two channel power
amplifier’s RCA input terminals.
• Connect the left and right front panels to the additional two channel power amplifier’s
loudspeaker binding posts.
• Connect the rear loudspeakers and the center panel to the outboard amplifier’s
appropriate loudspeaker output terminals.
• Adjust the ‘speaker size’ in the receiver’s menu to LARGE. This will cancel the
receiver’s LFE output and route all the low frequencies to the front channels.
• Follow Procedure B for adjusting the subwoofer.
+ The connection scheme is according to Figure 6. Instead of applying one five channel amp, you use
combinations of mono, two channel and/or three channel chassis.
(Figure 6) If you use a separate Dolby Digital/DTS processor and outboard power
amplifiers.
• You can only use the subwoofer’s special high pass filter facilities by putting the
subwoofer into the circuit, driving the left and right electrostatic front panels.
• Connect the processor’s left and right RCA pre amp out terminals to the subwoofer’s
left and right line in RCA terminals.
• Connect the subwoofer’s line out RCA terminals to the two channel power amplifier’s
RCA input terminals for driving the front channels.
• Connect the left and right front panels to the two channel power amplifier’s
loudspeaker binding posts.
• Connect the rear loudspeakers and the center panel to the other power amplifier’s
appropriate loudspeaker output terminals.