Frymaster Super Runner 38 Series - Manual (Page 6)

5
3. INSTALLATION
3.1 POSITIONING:
a. Initial Installation: If installed with
legs, do not push against any unit
edges to adjust its position. Use a
pallet or lift jack to lift it slightly and
place it where it is to be installed.
b. Relocating The Fryer: If relocating a
fryer installed with legs, remove all
weight from each leg before moving.
If a leg becomes damaged during
movement, contact your service
agent for immediate
repair/replacement of that leg.
3.2 LEGS:
a. Install legs (or optional fixed casters)
near where the fryer is to be used, as
neither is secure for long transit. Unit
can be curb mounted or equipped with
the legs or casters provided.
b. After unpacking, use a pallet or lift
jack to raise the fryer about a foot
before installing the legs.
c. Insert the threaded leg screw into leg
support coupling.
d. Turn the leg clockwise until the leg is
hand tight against the leg support
assembly.
e. Then lower gently to prevent undue
strain to the legs and internal mounting
hardware. Using a pallet or lift jack to
lift rather than tilting is recommended.
f. Proceed to 3.4 Leveling and follow
instructions to ensure the fryer is level
before using.
3.3 CASTERS:
a. If casters are desired, install fixed-type
casters only on the rear of this fryer.
b. Install fixed-type casters near where
the fryer is to be used, as casters are
not secure for long transit. Unit can
be curb mounted or equipped with
either the legs or casters provided.
After unpacking, use a pallet or lift
INSTALLING LEG INTO
LEG SUPPORT ASSEMBLY
HAND-TIGHTEN THE LEG
CAUTION
THIS FRYER MAY TIP AND CAUSE
PERSONAL INJURY IF NOT SECURED IN
A STATIONARY POSITION. REMOVE
ALL SHORTENING BEFORE MOVING
FRYER AS IT MAY CAUSE SEVERE
BURNS UPON CONTACT.
WARNING
DO NOT INSTALL SWIVEL CASTERS
ON THIS FRYER. THE FRYER MAY TIP
AND CAUSE PERSONAL INJURY.