beautypg.com

Installation instructions – Fisher & Paykel RF610A User Manual

Page 9

background image

7

Installation instructions

11

Attach double sided foam to the back of the water filter head as shown in

Diagram 5. Write the date to be replaced on the filter (date installed + 6
months). Remove double sided foam backing and attach filter to the desired
position as located in step 10 (refer to previous page).

12

Run the 6 mm (¼”) tubing to back of the fridge ensuring there is enough

tubing to pull out the refrigerator for service.

13

Connect tubing into the water (solenoid) valve located on the right hand side of

the unit (compressor) compartment as shown in Diagram 7. Beware of hot pipes.

14

Pull gently on tubing to ensure it is locked in as shown in Diagram 8.

15

The completed installation should look like Diagram 9 on page 8.

Fig.8 Waterline connection
to refrigerator

Diagram 7

Diagram 6

Diagram 8

16

Turn isolating tap on and check that all connections are dry and free of drips. If not, please alert

the plumber.

17

Coil water line tubing behind the fridge. Push your refrigerator into place being careful not to

kink or squash the water line running into the water (solenoid) valve.

18

Read pages 9 – 14 carefully, and then turn refrigerator on.

19

The first time you require water out of the dispenser, there will be a delay while the water

reservoir fills up.

20

Run a further 3 litres (3 qt) through the system, stopping intermittently to ensure the reservoir is

flushed out. Failure to do this will result in excessive dripping from your dispenser.

21

Press

until the Ice menu is highlighted then press to turn on the ice maker. Press

together to force a cycle. The ice tray will flip. Force another cycle. The ice tray will flip and spill
the water into the ice bin. Empty water and replace bin.

22

You are now ready to enjoy chilled water and ice dispensing from your Active Smart™ refrigerator.

Please note that once installation is complete a few drips may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.

Diagram 5

Fig.7 Double sided
foam attachment