FUJITSU AOU15RLQ - Manual (Page 6)

En-4
PREPARATION
CAUTION!
● Take care to prevent infants from
accidentally swallowing batteries.
● When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
● If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
● Dead batteries should be removed
immediately and disposed of properly,
either in a battery collection receptacle
or to the appropriate authority.
● Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit’s operating range becomes ap-
preciably reduced, replace the batteries
and press the RESET button with the tip
of a ballpoint pen or other small object.
Turn on the Power
1 Connect the Power Supply Plug (Fig. 1
F) to an electri-
cal outlet; in the case of a direct line connection, turn
on the circuit breaker.
Load Batteries (AAA/R03/LR03
ЧЧЧЧЧ 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the mark.
2 Insert batteries.
Be sure to align the battery polarities ( ) correctly.
3 Close the battery compartment lid.
Set the Current time
1 Press the CLOCK ADJUST button (Fig. 6
X).
Use the tip of a ball-point pen or other small object to press the button.
2 Use the TIMER SET (
/ ) buttons (Fig. 6 V) to ad-
just the clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
one-minute increments; hold the buttons depressed to change the time
quickly in ten-minute increments.)
3 Press the CLOCK ADJUST button (Fig. 6 X) again.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
● The Remote Control Unit must be pointed at signal receiver (Fig. 3 4) to operate
correctly.
● Operating Range: About 23 ft.
● When a signal is properly received by the air conditioner, a beeping sound will
be heard.
● If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
3 To remove the Remote
Control Unit (when use at
hand).
1 Mount the Holder. 2 Set the Remote Control
Unit.
Screws
Insert
Press in
Slide up
Pull out