Fisher M-SCOPE CZ-3D User Manual

Page 6

5. With the stem length properly adjusted, wrap the

loop cable tightly around the center section stem

and secure it with the two Velcro straps. Connect

the cable connector to the control housing.

CAUTION: Make sure that the cable is not pulled tight

at the control housing and that you have enough slack

at the search coil to adjust it to any angle.

6. With the shaft length and coil angle properly

adjusted, you should be able to move into your

“search” position (as shown in illustration below) by

leaning forward very slightly and raising your arm (still

straight) until the search coil is about 2 inches above

the ground and 12 inches in front of your foot. The

search coil should be parallel to the ground and may

have to be slightly readjusted at this point.

Figure 2. SEARCH POSITION.

Adjust the stem length and coil

angle so the coil rests ﬂat on

the ground about 6 to 12 inches

in front of your foot. Move

into your “search” position by

leaning forward slightly and

raising the coil about 2 inches

off the ground. This should put

the search coil out about 12 to

18 inches in front of your foot.

SETTING UP