FELLOWES SB-89CI - Manual (Page 4)

AUTO AUTO
15
AUTO AUTO
15
AUTO AUTO
AUTO
AUTO AUTO
AUTO AUTO
15
AUTO AUTO
15
AUTO AUTO
AUTO AUTO
15
AUTO AUTO
15
AUTO AUTO
15
SafeSense ® is active and ®
working properly
SAFESENSE ® TECHNOLOGY OPERATION
2
Press ( ) ON to
activate (blue)
PAPER OR CD/CARD
BASIC SHREDDING OPERATION
1
To shred CDs rotate
CD flap into place
4
JAM PROOF SYSTEM OPERATION
Eliminates frustrating jams by preventing overloads and powering through misfed paper.
Feed into paper entry
and release If paper is misfed and
stops shredding
Stops shredder immediately when hands are too close to the opening.
Touch test area and
look for the SafeSense
®
indicator to illuminate
Turn the shredder ON
( ) to activate SafeSense
®
SafeSense ® is deactivated when ®
indicator is flashing
Shift override switch to
the “active” position,
reactivating SafeSense
®
Confirm the indicator is no longer
flashing and retest by putting
your hand on the test area
Shredder will take fewer sheets,
but if indicator is below yellow,
you can add more sheets without
fear of jamming
2
Increase the number of sheets
being fed up to the top yellow light
to maximize your productivity If there is too much paper for
the shredder to power through,
it will reverse the paper out for
easy removal Reduce paper quantity to an
acceptable amount and refeed into
paper entry
If too many sheets, indicator will
light up to red and shredder will
not take paper Remove several sheets until the
indicator is below red and the
shredder will take the paper Automatic correcting action
will power through the misfed
paper, so shredding can
continue
SET-UP AND TESTING MISFED PAPER
SET-UP AND TESTING
2
AUTO AUTO
15
3
2 3 1 2
AUTO AUTO
15
3
1
3
3
Feed into paper
entry and release
FLASHING INDICATOR
1
3
disconnect power
switch in ON (I) position.
Continuous operation:
20-minute maximum
NOTE: Shredder runs brie
fly
after each pass to clear entry.
Continuous operation beyond
20-minutes will trigger
40-minute cool down period.
Hold CD/card at edge,
feed into CD/Card flap
entry and release
5
When finished
shredding set
to Off ( )
6
1
AUTO AUTO
15
3
Misfed paper can also be
addressed by manually using
forward and reverse (See
Maintenance & Troubleshooting)
2
AUTO AUTO
15
2