FELLOWES 120-2 - Manual (Page 4)

3
English
Product Profile
This product is built to shred paper, staples, small paper clips
and credit cards
. It is not built to shred adhesive labels, trans-
parencies, newspaper, cardboard, large paper clips, or plastic
(other than credit cards). Attempting to shred items not intended
for this shredder may cause damage.
Strip-Cut Strip-cut Confetti-cut
(120-2) (120-2) (120C-2)
Sheet capacity* 18-20 sheets 16-18 sheets 12-14 sheets
Paper shred size 5,8 mm 3,9 mm 3,9 x 25 mm
Maximum paper width 241 mm 241 mm 241 mm
Recommended daily capacity 4,000 sheets 4,000 sheets 2,000 sheets
*Based on A4 (70 g/m 2 ) paper with shredder operating at rated voltage; heavier paper, high humidity, or other than rated
voltage may reduce sheet capacity.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
While setting up shredder
• Check shredder for damage or defects; some paper particles in the basket are normal
due to product testing and does not indicate a defect.
• Avoid touching exposed blades on underside of confetti-cut shredder head.
• Plug power cord in an outlet that can easily be reached. The plug is the primary electri-
cal disconnect.
• Make sure the electrical rating listed on the serial label (located inside, just below top of
shredder) matches the available electric power.
• Do not place shredder near or over a heat or water source.
While operating shredder
• Keep hands and hanging objects (jewelry, ties, loose clothing,
long hair, etc.) away from paper entry.
• Keep children and pets away from the shredder.
When not in use
• Always turn off and unplug shredder.
• Unplug before emptying basket.
• Do not open shredder head: Danger of electric shock.
Opening shredder head will void the warranty.
NOTE: Do not use flammable synthetic oil, petroleum-based products or aerosols of any
kind on or near product at any time.