FELLOWES Powershred 520HS - Manual (Page 7)

520
520 CC
Paper shredder 520 HS
Edition 03/98 1.490.999.112 7
Electronic motor overheated
Red LED on keyboard lights
• Shredder switches off automatically.
• Allow shredder to cool down for approx.
15-20 min.
– Press green arrow button at least 4 sec
Cabinet door contact ajar / bag full
Red LED lights
• Shredder switches off automatically.
• Make sure cabinet door is properly
closed and/or empty waste container.
– Press green arrow button at least 4 sec
9. Maintenance
(Cross cut unit only)
– When shredding capacity drops or the
noise increases.
• Spray special cutting block oil onto
cutting system.
• Run cutting system forward and back-
ward several times without feeding
paper.
• Continue shredding.
10. Checklist for Inoperative Machine
If the equipment does not work properly, please
check the following points first:
– Is the plug inserted?
– Is the switch turned on?
– Is the cabinet door closed?
– Is the waste receptacle full?
Empty waste bag.
– Is there a paper jam in the shredder?
See Malfunctions
– Is the motor overheated?
Switch machine off and allow motor to
cool down for approximately 15-20 min.
If none of the above applies and the equipment still
does not run, please contact our customer service
department.
Feeding continuous forms
– Pass the leading edge of the form under
the paper guide roller (1) and into the
paper feed opening (2).
1 2
8. Malfunctions
Paper jam
Red LED on keyboard lights
• Shredder reverses automatically and
runs in this mode for a few seconds.
• Pull out jam and remove excess paper.
Caution!
Do not attempt to force the jammed
material through the machine by
alternating the cutting system between
forward and reverse.
If paper jam cannot be removed
• Hold down reverse button until paper
can be pulled out of the cutting system.
• Press green arrow button at least 4 sec
• Continue shredding in smaller
quantities so as not to jam the machine
further.
or
• Continue shredding in smaller
quantities so as not to jam the machine
further.
• The shredding process is started by a
photo–cell in the paper feeding opening
Note:
The 520 HS will not run forward again
unless the jammed material has been
completely removed from the throat.