Fortress Technologies ALARM COMBO SYSTEM FS-50 - Manual (Page 12)

12
WIRING: 4-PIN Shock Sensor (22 Gauge wires)
SHOCK SENSOR: The sensor supplied with this system does not require any additional wiring. Simply mount the
sensor in a suitable location, plug it in, and adjust the sensitivity. There are 2 LED’s on the shock sensor to assist
you in adjusting sensitivity. The Green LED indicates the “Warn Away” level and the Red LED indicates a full alarm
shock sensor violation.
Use the adjustment knob to set the sensitivity of the sensor. The adjustment knob adjusts both Pre-Warn and alarm
trigger.
GREEN LED RED LED
(-) PRE-WARN
(-) TRIGGER
GROUND
12 VOLTS
YELLOW
ORANGE
BLACK
RED
(Trigger) (Pre-Warn)
Adjustment
SHOCK SENSOR