First Virtual Communications PS1010-3A - Manual (Page 5)

IBBI Electronics 5
Voltmeter range 0-35V
5 Device operation
5.1 Setting output voltage
• Put VM/Vout switch [(10)] to Vout position
• Put C/V switch [(8)] to V position
• Volt LED indicator will light up [(4)]
• [(3)] will display “U” for Volt
• Adjust the voltage controller [(5)] to get the
required value.
• The value will be displayed on [(2)] with one
decimal place
Note: Make sure to keep reasonable current limiting
value before setting output voltage so that current
control (CC) will not take over.
5.2 Setting current limit
• Press and hold C-SET button [(7)].
• Then display[(2)] will show the present current
limit in Amperes.
• [(3)] will display “A” for Current
• Now rotate the current controller knob [(6)]
while looking at the display. Stop when the
desired value appears.
Note: The output voltage will be automatically be
controlled if the external device tries to drag current
more than the set limit.
5.3 Viewing actual current flow
• Power up the DUT with PS1010-3A