FilterStream V2400 User Manual

Page 17

CLEANING/REPLACING FOAM AND
HEPA FILTERS
To remove/replace the
Filter (either foam or
HEPA) from the vac-
uum, please follow
these steps:
(a) Remove the Filter

Cover from the vac-
uum Handle/
Housing.

(b) Remove the Filter

from the Handle/
Housing.

follows.

Foam Filter Cleaning:
Wash the Foam Filter in
warm, soapy water until clean. Allow the Foam
Filter to dry before reinserting into the
Handle/Housing.

Note: Use only mild soap. Avoid detergents,

chemical cleaners or solvents as these may dam-
age the plastic.

HEPA Filter Cleaning: Use your finger to lightly
clean the paper surface of the HEPA Filter, clear-
ing off any dirt, dust, and hair.

NOTE 1: Do not wash the HEPA Filter. Water
will permanently damage the filter.

NOTE 2: Under normal household use, the
HEPA filter will last six (6) months to one (1)
year

(d) Insert either side of the clean Filter (or if neces-

sary, a new Filter) into the Handle/ Housing,
then snap-on the Filter Cover and reattach the
Bowl to the Handle/Housing (making sure that
the Pre-Filter is inserted into the Bowl).

NOTE: Filters should be replaced periodically to
provide best performance or when the filter has
been damaged.

M A I N T E N A N C E / F I L T E R R E P L A C E M E N T