J1 j2, Mq p n – Flymo TWISTER 2700XV User Manual

Page 6

Cable Restraint
1. Form loop in mains cable and push the loop

through the slot (J1).

2. To secure, position loop over the hook and

pull the cable back through the slot (J2).

How to Use

WARNING
The use of eye protection is recommended. The use
of ear protection is recommended. To prevent dust irri-
tation, the wearing of a face-mask is recommended.
Never point your product at bystanders.
Using As A Blower
Blow Mode - The product will blow debris from pa-
tios, paths, driveways, lawns, bushes, borders etc.
1. Point nozzle towards the ground.
2. To start squeeze the switch lever (K).
3. Stand back from debris to be cleared.
4. To control the speed of the blow mode, use the variable

speed dial. Move the dial forward for a faster speed
and backwards for a slower speed (L).

5. Point the tube towards the debris and slowly

approach (M).

6. To stop release the switch lever.
• If Blow performance is reduced, the blow outlet

may be blocked. Switch off the product and dis-
connect from the mains electricity supply. Re-
move the Blow Tube and clear any blockage in
the blow outlet using a blunt implement (N)

Using As A Vacuum
Vacuum Mode - In this position your product will
pick up leaves, small twigs and garden debris.
• For best performance, turn speed control to

maximum.

1. Position the tube slightly above the debris,

squeeze the switch lever (E) and move the
product slowly back and forth (P).

3. Do not force the tube into the debris as this will

impair performance.

4. To stop release the switch lever.
• If Vacuum performance is reduced, the Debis

bag inlet may be blocked. Switch off the prod-
uct and disconnect from the mains electricity
supply. Remove the Debris Bag and clear any
blockage in the Debris Bag inlet using a blunt
implement (Q)