Fisher & Paykel HS60CSRX1 - Manual (Page 7)

5
Mounting to cabinetry sides
Fix rangehood to your wall units, with 2 screws in each side into the vertical panels. To do this:
1
Slide out the drawer and remove filter. You will see two mounting holes running through the
moulded sides (see Fig.7).
2
Remove the thin plastic skin (A) from each side fixing hole. An 8 mm diameter drill bit is
recommended.
3
Position slideout (ensuring unit is level) and fix in place using screws and hollow dowels through
each side fixing hole (see Fig.8). (Check screw length with thickness of cabinet panels).
The rangehood’s plug can be easily plugged into the nearest wall socket, or if connected directly
into the house wiring, a registered electrician is required.
Installation instructions
Fig.7 Fixing holes
Fig.8 Side mounting
Hollow Dowel
Slideout Slide
Cupboard