beautypg.com

Installing your wine cellar – haier HVCE24 User Manual

Page 6

background image

Unpacking Your Wine Cellar
1. Remove all packaging material. This includes the foam base and all adhesive

tape holding the wine cellar accessories inside and outside.

2. Inspect and remove any remains of packing, tape or printed materials before

powering on the wine cellar.

Leveling Your Wine Cellar

• Your wine cellar has four leveling legs which are located in the front and rear

corners of your wine cellar. After properly placing your wine cellar in its final
position, you can level your wine cellar.

• Leveling legs can be adjusted by turning them clockwise to raise your wine

cellar or by turning them counterclockwise to lower your wine cellar. The wine
cellar door will close easier when the leveling legs are extended.

Electrical Requirements

• Make sure there is a suitable power outlet (115 volts, 15 amps outlet) with

proper grounding to power the wine cellar.

• Avoid the use of three plug adapters or cutting off the third grounding in

order to accommodate a two plug outlet. This is a dangerous practice
since it provides no effective grounding for the wine cellar and may result
in shock hazard.

Use of Extension Cord

• Avoid the use of an extension cord because of potential safety hazards under

certain conditions. If it is necessary to use an extension cord, use only a 3-wire
extension cord that has a 3-blade grounding plug and a 3-slot outlet that will
accept the plug. The marked rating of the extension cord must be equal to or
greater than the electrical rating of the appliance.

5

English

INSTALLING YOUR WINE CELLAR

This manual is related to the following products: