Hotpoint WD52 - Manual (Page 3)

3
CONNECT TO THE
Installation
4
DRAINAGE SYSTEM... we recommend one of the following:
OTE: ALTHOUGH YOU MAY NEED TO
MOVE THE HOOKED END SUPPORT
LONG THE GREY DRAINAGE HOSE,
DO NOT REMOVE IT.
WHICHEVER DRAINAGE METHOD
YOU USE, MAKE SURE THAT THE
HOOKED END SUPPORT IS FIXED
EVEL TO, OR ABOVE THE ‘MINIMUM
DRAINAGE HOSE HEIGHT LINE’*
*see Getting to Know your Appliance)
P YOU
WO FRONT FEET ARE
DS FIRM AND LEVEL.
isk and The Foot
n ONLY the locking disk
the two front feet until
h is up against the base
he machine.
2
REMOVE TRANSIT BRACKETS...
IMPORTANT:
Internal transit brackets
are fitted to prevent
damage during transit
and MUST be removed
before use...
Failure to do so may
cause damage to your
machine!
STANDPIPE METHOD UNDER SINK METHOD
OR
Attach the GREY
drainage hose to the
under sink drainage
unit securely, using a
hose clip. Fix the hooked
end support at
a minimum
800mm from
the floor.
cut off the blocked
end of the under sink
drainage unit.
7
READY...
TO CHECK ALL PARTS OF
CLEAN THE INSIDE OF YO
SELECT A 95˚ WHITE CO
6
CONNECT TO THE POWER SUPPLY...
PLUG YOUR MACHINE INTO AN ELECTRICAL SOCKET WHICH IS
EASILY ACCESSIBLE. SWITCH ON
NOTE: Hotpoint recommend
extension leads are not used.
Move your machine into position,
take care not to trap or kink the
hoses.
WITHO
THIS WILL TAKE APP
.............................
Standpipe height:
minimum 500mm
from the floor.
Insert drainage hose
approximately 100mm
into the standpipe.
✗
Slide and push worktop lid back
into position, ensuring front edge is
correctly located into the console.
Replace the work top lid
using the 3 original screws.
Remove and
retain 3 screws
from the back of
the worktop lid
From the rear of the
machine, grip sides of
the worktop lid, lift, slide
and pull towards you.
Remove 4 screws
and the rear transit
bracket - retain.
Remove 3 screws
and front transit
bracket - retain.
800mm
from floor
Hooked End Support
PLEASE USE THE NEW HOSES
SUPPLIED, FITTED TO THE
MACHINE.
Old hoses may cause leaks
due to worn out washers.
DO NOT REMOVE!