Personalisations, Setting the temperature, Functions – Hotpoint hvl 211 User Manual
Page 9
9
G B
Function
Effect
Comments
Enabled with
programmes:
Super
Wash
Allows for an
impeccable wash,
visibly whiter
than a standard
Class A wash.
This function is incompatible with the QUICK WASH function.
A, B, C, D,
E, F, G, H
Easy Iron
This option
reduces the
amount of
creasing on
fabrics, making
them easier to
iron.
When this function is set, programmes F, G, H ,K, L, N will end
with the laundry left to soak (Anti-crease) and the Rinse cycle
phase LED will flash.
- to conclude the cycle, press the START button;
- to run the draining cycle alone, set the knob to the relative
programme (R) and press the START button.
All
programmes
except for
A, B, J, R
Quick
Wash
Cuts the
duration of the
wash cycle by
30%.
This function is incompatible with the SUPER WASH function.
A, B, C, D,
E, F, G, H
Extra
Rinse
Increases the
efficiency of
the rinse.
Recommended when the appliance has a full load or with large
quantities of detergent.
A, B, C, D, E,
F, G, H, M, N
Personalisations
Setting the temperature
Turn the VARIABLE TEMPERATURE knob to set the wash temperature (see Programme table on page 8).
The temperature can be lowered, or even set to a cold wash (Cold).
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below;
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Note: to avoid excessive vibrations, before every spin cycle the machine distributes the load in a uniform manner
by continuously rotating the drum at a speed which is slightly faster than the normal washing speed.
When, despite repeated attempts, the load is still not evenly distributed, the machine spins at a lower speed
than the set frequency.
If the load is excessively unbalanced, the machine attempts to distribute it instead of spinning.
The balancing attempts may extend the total duration of the cycle, up to a maximum of 10 minutes.