haier 311209J User Manual
Hot melt dispense guns, Instructions - parts
311209J
Instructions - Parts
Hot Melt
Dispense Guns
For dispensing non-flammable hot melt thermoplastic sealants and adhesives.
3500 psi (24.1 MPa, 241 bar) Maximum Working Pressure
See page 2 for model information.
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
TI7702b
TI7700b
Bottom feed model
Top feed model
Table of contents
Document Outline
- Models
- Warnings
- Installation
- Connect Heated Hose
- Connect Electrical Cable
- Ground the System
- Pressure Relief Procedure
- Trigger Lock
- Operation
- Heatup
- Dispensing
- Shutdown
- Troubleshooting
- Service
- Install New Heater Cartridge(s), RTD Sensor, or Switch
- Inspection Frequency
- Adjust Needle Assembly
- Service Valve Stem and Seal
- Notes
- Parts
- Accessories
- Technical Data
- Graco Standard Warranty
- Graco Information