Electrical connection – Hotpoint SE100PX User Manual

Page 5

DATA PLATE

Dimensions

width 43.5 cm
height 32 cm
depth 41,5 cm

Volume

lt. 58

Electrical
connections

voltage: 230-240V ~ 50Hz
maximum power absorbed
2560-3050W

ENERGY LABEL

Directive 2002/40/EC on the label
of electric ovens.
Standard EN 50304

Energy consumption for Natural
convection – heating mode:
Convection mode.

Declared energy consumption for
Forced convection Class – heating
mode: Baking.

This appliance conforms to the
following European Economic
Community directives:
73/23/EEC of 19/02/73 (Low
Voltage) and subsequent
amendments;
- 89/336/EEC of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments;
- 93/68/EEC of 22/07/93 and
subsequent amendments.

Electrical Connection

Electrical connection

The electrical connection to the mains must be made

on the appliance. The power voltage and frequency

are as indicated on the rating plate.

! THIS APPLIANCE MUST BE EARTHED.

Connecting the power supply cable

To open the terminal board:

Using a screwdriver, press on the tabs situated on

each side of the terminal board cover.

Pull open the terminal board cover.

To connect the power supply cable, proceed as

follows:

Unscrew the cable clamp screw and the contact

screws L-N-6.

Fasten the wires beneath the screwheads using the

following colour scheme: Blue (N) Brown (L)

Yellow-Green 6

Fasten the power supply cable in the

corresponding cable clamp and close the cover.

Electrical Connection:

Voltage Frequency: 230

V-1+N 50Hz

Fuse Section: 16A

Supply cable: 3x1.5mm

You can connect your oven to the system means of a

terminal board. Refer to above information for the

minimal cable sections and the calibration of the

protective elements according to the connection.

If the appliance is installed with a junction box, an

omnipolar circuit breaker - with a minimum contact

opening of 3mm - should be installed between the

appliance and the mains.

Power cable supply connection to the electrical

mains:

We recommend you use a power supply cable which

is long enough to allow you to take the oven out of its

recess in the event of maintenance operations (only

use HAR - H 05 - RRF quality cables fitted with a plug

conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even

when replacing the oven lamp.

Using the appliance without correct earthing is

highly dangerous.

! After connecting the appliance to the flexible

cable, tighten all the screws on the terminal board.