Husqvarna HUV 4214 - Manual (Page 43)

Gearcase Lubrication
Rear transaxle:
Clean and install the drain plug (2) and washer before filling the rear transaxle with new lubricant (Figure 23). Tighten
the drain plug to 8 ft-lb (10.8 N·m). Remove the fill plug/dipstick (2) (Figure 25). Use a funnel and tube to fill the
transaxle through the fill plug/dipstick hole (1) located on the top of the rear transaxle (Figure 24). See Periodic
Lubrication Schedule on page 33. Replace rear transaxle dipstick and tighten to 35 in-lb (4 N·m).
2 1
808
Figure 23 Rear Transaxle Drain Plug
819
Figure 24 Rear Transaxle Check/Fill Plug
2
3
2
1
1. Full Level 2. Safe Level 3. Low Level
820
Figure 25 Rear Transaxle Dipstick
824
Figure 26 Rear Transaxle Lubricant Level Check
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner’s Manual Page 41