Harbor Freight Tools USGENERAL 97071 - Manual (Page 4)

Page 4 SKU 97071 For technical questions, please call 1-800-444-3353.
speciFications
Weight Capacity 1,800 Pounds
Wheel Size 16” to 26” L
Maximum Motorcycle Wheel Footprint* 3” to 5” W
* The “footprint” of the motorcycle is the total size of the tires where they contact
the floor. Motorcycles come in many different designs – certain large or cus-
tomized motorcycles may not work properly with this dolly. Do not modify this
product to fit any motorcycle it would not normally work with.
unpacking
When unpacking, check to make sure that the item is intact and undamaged. If
any parts are missing or broken, please call Harbor Freight Tools at the number shown
on the cover of this manual as soon as possible.
set up instructions
read the entire iMportant saFety inForMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
note: For additional information regarding the parts listed in the following pages, refer
to the Assembly Diagram near the end of this manual.
assembly
Measure the motorcycle wheel prior to assembly so that the Motorcycle Stand
can be adjusted to fit the wheel length. The Motorcycle Stand will fit most stan-
dard motorcycles currently on the market. However, some models with especially
wide tires or custom low-profile front fenders will not fit.
Use 2 Bolts (5) to mount the Cradle Stop (7) to the Base (9); secure with Wash-
ers (11) and Nuts (12).
Mount the Support Arm (6) to the front of the Base using 3 Bolts (1), Washers
(11), and Nuts (12).
Insert Pin (10) through the mounting holes and Wheel Adapter (8); secure with
Washer (4) and R Pin (3).
Securely tighten all hardware before use.
the Motorcycle stand must be mounted securely before use.
1.
2.
3.
4.
5.
6.